Schneider Magelis MPCYT50NAN00N Touch Screen Monitor

FAQ:

Question: How to install the Schneider Magelis iDisplay MPCYT50NAN00N Unit?

Answer:

1. Place the unit face down on a dry, soft surface and attach the gasket to the rear side, in the installation groove (see picture below):

2. Check that the gasket is correctly attached to the unit. The upper surface of the gasket should protrude evenly approximately 2 mm (0.08 in.) out of the groove.
Note: When installing the iDisplay unit's installation gasket, avoid contact with the sharp edges of the iDisplay frame, and press the gasket completely into its groove.

3. Insert each installation fastener securely into the slot’s recess at the top and bottom of the unit:

4. Attach and Secure the Rear Installation Attachments:

5. Insert each of the fasteners. Pull the fastener back until it is flush with the rear of the attachment hole.
Note: The corresponding installation attachments can be purchased as spare parts with the maintenance kit ref.: MPC YK 50 MNT KIT.

6. Use a screw driver to tighten to 0.5 N•m (4.5 lb-in) each of the fastener screws and secure the iDisplay in place:

7. iDisplay Viewing Angle.
Ensure that the panel’s viewing angle is tilted no more than 30 degrees from parallel to the operator (i.e. operator is directly in front).

Question: When an alarm appears on Magelis Schneider MPCYT50NAN00N Protective Film Touch Panel Glass Terminal, what does it means?

Answer:

• The ALARM indicator light flashes. The alarm is stored in the alarm list. The alarm can be acknowledged by the operator directly on the application page by pressing the ENTER key or for touchscreen terminals.
• The alarm relay is closed (if this function is selected).
• The alarm strip is updated.